Salt Generator Flow Switch for SWS Generators
This critical safety component ensures your salt chlorine generator only operates when there is active water flow. It protects your equipment from damage and prevents hazardous gas buildup by shutting down the cell when the pump is off.
Why You'll Love It
- System Protection — prevents the salt cell from firing without water, extending its lifespan.
- Accurate Sensing — high-quality paddle design detects even low flow rates for consistent safety.
- Plug-and-Play — features the standard connector for a quick, hassle-free replacement process.
- Peace of Mind — ensures your pool automation stays synchronized with your filtration pump.
Best For
- SWS Series Salt Water Generators
- Replacing "No Flow" error indicators
- Routine salt system maintenance
- Ensuring safe chlorine production
Quick Tips
- Power off your salt system and pump before attempting to unscrew the old switch.
- Note the direction of the arrow on the switch; it must point in the direction of water flow.
- Use thread seal tape (Teflon) to ensure a watertight fit without over-tightening.
- Replace immediately if your system shows a "No Flow" light despite the pump being on.
Key Features
Fit & Compatibility
Care & Storage
- Inspect the paddle for debris or calcium buildup seasonally.
- Ensure wires are tucked away from direct heat or sharp edges.
- Keep connection points clean and free of corrosion.
- Do not over-tighten during installation to avoid cracking threads.